Stacking Guide - BL!NKEY

[BL!NKEY]

EDIT By -:Undertaker:- ; There are now more updated ways to stack, for guides on how to do them go on Bl!nkeys website which is www.Stacking.co.nr !

1. Regular Stacking against a wall without rollers

You will need:
2 Z shelfs
Whatever furni you want to stack

First Step - Put one Z shelf down where you want to stack.

Second Step - Put Furni that you want to stack on top of that Z shelf.

Third Step - Put another Z shelf on top.

Fourth Step - Take bottom Z shelf away.

Fifth Step - Take the furni that you are stacking (candles) and
move them under any chair that is in the room. The furni should
not move but its order will change. (You can also move the furni
under the Z shelf but I prefer using seats)

Sixth Step - Take the second thing that you want to stack and
put it on top of the rest. If it doesn't work repeat step 5.

Seventh Step - Put the other Z shelf on top of the stack.

Eighth Step - Remove the bottom Z shelf.

Ninth Step - If you want to keep stacking higher you have to
take the furni that you are stacking (candles) and move them
under the seat like step 5. Be sure to move both candles to the seat.

Tenth Step - Put another object on top of the Z shelf.
If this doesn't work repeat step 9.

Eleventh Step - Move the Other Z shelf on top to stack higher.

Twelfth Step - Remove the bottom Z shelf.

Thirteenth Step - Move all three objects (candles) to the seat.

Fourteenth Step - Put another object on top.

To stack higher just repeat steps 11-14

[BL!NKEY]

2. Flat stacking in the middle of the room with rollers

You will need:
2 Z shelfs
2 Rollers (more rollers if you want to stack more than one furni)
Whatever furni you want to stack

First Step - Put 2 rollers down and make them face each other.

Second Step - Put Z shelf on top of the rollers

Third Step - Put the other Z shelf on top of that.

Fourth Step - Remove bottom Z shelf

Fifth Step - Put Z shelf on top by placing it on the roller
under the stacked Z shelf.

Sixth Step - Keep repeating step 4 and 5 until you have
the height you want above the ground

Seventh Step - Put the furni that you want above on top of
the Z shelf by placing it on the roller below.

Eighth Step - Remove the Z shelf.

Ninth Step - Put the furni that you want flat stacked on the roller.
You will have to time it right so you put the furni on the roller
right as the other high furni is rolling toward it.

Tenth Step - If you wanted to you could pick up one roller
when the furni is not on it and it will roll to the ground.
Or you can roll it onto a Rug or Petal to make a cool flat stacking effect.

Eleventh Step - Move the rollers away and you have the finished flat stacked seat with something above.

If you wanted to you could put more furni on top but you just have
to have more rollers down in the room if you want to stack more.

[BL!NKEY]

3. Close stacking without rollers

You will need:
2 Z shelfs
Large Mode Dining Table
Area Coffee Table
Mode Corner Cabinet/Desk
Lodge Occasional Table
Any seat (I used Stool)
Whatever furni you want to close stack

First Step - Put Z shelf down wherever you want to stack.

Second Step - Put another Z shelf on top

Third Step - Move bottom Z shelf onto seat. (nothing will look different)

Fourth Step - Put the Object that you want to stack on in the pile.

Fifth Step - Remove the top z shelf.

Sixth Step - Put the Large Mode Dining Table on top of the Z shelf.

Seventh Step - Move the Z shelf and the first object (candle) onto the seat. (nothing will look different)

Eighth Step - Put another Object in the pile.

Ninth Step - Remove Large Mode Dining Table.

Tenth Step - Move the Two objects (candles) onto the seat. (nothing will look different)

Eleventh Step - Put the Area Coffee Table on top of the Z shelf.

Twelfth Step - Move Z shelf and the Two objects (candles) onto the seat again. (nothing will look different)

Thirteenth Step - Put a third object (candle) onto the pile.

Fourteenth Step - Remove Area Coffee Table.


See next post

[BL!NKEY]

Fifteenth Step - Move the Three objects (candles) onto the seat. (nothing will look different)

Sixteenth Step - Put the Mode Corner Cabinet/Desk on top of the Z shelf.

Seventeenth Step - Move Z shelf and the Three objects (candles) onto the seat again. (nothing will look different)

Eighteenth Step - Put a fourth object (candle) onto the pile.

Nineteenth Step - Remove Mode Corner Cabinet/Desk.

Twentieth Step - Move the four objects (candles) onto the seat. (nothing will look different)

Twenty-first Step - Put the Lodge Occasional Table on top of the Z shelf.

Twenty-second Step - Move Z shelf and the four objects (candles) onto the seat again. (nothing will look different)

Twenty-third Step - Put a fifth object (candle) onto the pile.

Twenty-fourth Step - Remove Lodge Occasional Table.

Twenty-fifth Step - Move the five objects (candles) onto the seat. (nothing will look different)

Twenty-sixth Step - Put the other Z shelf on top of the bottom one.

Twenty-seventh Step - Move the bottom Z shelf away.

Twenty-eighth Step - Go back to step 2 and put more objects on the pile. (Remember every time to move all the objects to the seat if it isn't working)

Keep repeating steps 2-27 and you can make a close stacked pile 31 high

[BL!NKEY]

4. Stacking Chairs

You will need:
Z shelf
However many chairs you want to stack
The same amount of rollers as chairs

First Step - Put all of the rollers down and have two facing each other where you want the stack to be.

Second Step - Put the Z shelf on the rollers.

Third Step - Stack something on the Z shelf.

Fourth Step - Remove the Z shelf.

Fifth Step - Put A chair under that object. You will need to time this right so when the object is rolling onto the roller you place the chair.

Sixth Step - Now you have to raise the stack which is hard. You have to get the timing right so right before the object rolls onto the roller you place down the Z shelf. (you might have to try a few times to get it to work)

Seventh Step - Remove the Z shelf

Eighth Step - Put another chair under the stack. You will need to time this right so when the object is rolling onto the roller you place the chair.

Ninth Step - Once again you have to raise it so place the Z shelf on the roller right before the stack moves.

Tenth Step - Remove the Z shelf.

Eleventh Step - Put another chair under the stack. You will need to time this right so when the object is rolling onto the roller you place the chair.

Twelfth Step - Just repeat steps 9-11 until you have it to the height you want. (Remember if it is not letting you put more furni in the rollers you have to make sure you have enough rollers laid down in the room.

When you are done you can rotate a roller to roll the stack off or you can move one roller and let it glide down.

[BL!NKEY]

5. Flat Stacking on Rugs/Petals where you can't use rollers

You will need:
Z shelf
A Rug Or Petal
Some Doormats and other furni

First Step - Put the rug down in the corner of the room.

Second Step - Put a Doormat down on the rug.

Third Step - Move the Rug on top of a seat. (Once done it shouldn't
look any different than it did before. It just changes the order of the furni.)

Fourth Step - Put a Z shelf on the Doormat.

Fifth Step - Put something else on the Z shelf

Sixth Step - Now by following the Regular Stacking guide you can stack higher from there.

Using this same technique you can do more stuff like:


Stacking is about just trying new things and being creative
if you are ever board, just sit in your room with some stacking
tools and see what you can do. You would be surprised.

[.Mike-]

wonderful guide + rep
this will definitly help :eusa_danc

[Ghert]

Awesome guide helped tremendously + rep to you sir

[H]

WELL DONE!!!!!!!! +rep

[Papershop]

Best ive ever seen. Covered all aspects Cheers + rep